Questions tagged [skr-v1.3]

The tag has no usage guidance.

5 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
0
votes
0answers
12 views

I am installing a BTT 24 v1.1 and it appears to be functioning in the 12864 mode with the exception of the top two lines which are gibberish

I am installing a TFT24 v1.1 and it appears to be functioning in the 12864 modes with the exception of the top two lines which are gibberish. I have attempted to block both the boot and the custom ...
0
votes
0answers
39 views

Hotend functioning inconsistently. PID completed normally, heating to quickly or not at all on print start up

I have a Xvico X1 printer which I had previously installed an SKR 1.3 on running Marlin, which was functioning normally. For Christmas I got a BLTouch, a heated bed and a Raspberry Pi for it, so I ...
0
votes
0answers
1k views

Error:Printer halted. kill() called! SKR 1.3 TFT35 3.0

I am trying to fix the very last error on my printer (custom built). Error:Printer halted. kill() called! This error occures about 5-10 minutes into a print (XYZ ...
0
votes
0answers
168 views

Printer froze mid print, stepper motor driver and MCU extremely hot afterwards. MCU seems dead now (?)

A strange problem occured while 3D printing. I've been printing for a long time now, and I consider myself fairly expeienced. normally, with every problem I've encountered with my printers (Anet, ...
0
votes
0answers
51 views

LV8729 on kossel issues with print dimensions (steps)

I've installed the an LV8729 on a kossel, configured with SKR 1.3 and marlin 2.0 with all the jumpers configured in the same way for 16 micro steps for X Y Z axis. Everthing seems fine the printer ...