Questions tagged [speed]

For questions that concern the performance of a 3D printing operation, or for improving the speed of the operation performed.

8 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
1answer
173 views

Dual Z-axis has different speeds (out of sync)

The Z-axis has two stepper motors, I'm using MKS GEN L V2.1 mainboard with TMC 2209 Drivers. My problem is that the motors are out of sync. How can I get them to work together? This is my code from ...
1
vote
1answer
768 views

Bed probing feed rates

I was watching a friend's Prusa run the bed-probe routine and I realized how pathetically slow mine is and takes forever. I want to speed it up. What parameters in Marlin's ...
1
vote
1answer
194 views

Extusion rate limiting and firmware retract

One frustration I have with Cura is that it has no way to set print speed in terms of a volumetric extrusion rate, when extrusion rate is the main physical limiting factor for how fast you can print. ...
1
vote
0answers
89 views

Hotend Will NOT Heat Up with Bullseye

So I just printed my Bullseye mod for my cr-10. But now I have a problem, when my hotend is trying to heat up it can't, because the cooling is to powerful. I know this because when I stop the fan with ...
0
votes
2answers
37 views

Estimating filament consumption in length per time

I printed a lot of models in last month. I spent 2 kg filament in total. I want to know how many hours have been passed while printing. As far as I read, 1 kg PLA (1.75 mm) is about 110 meters long. ...
0
votes
1answer
16 views

Creality 10S 3D

What fan speed should I use with PLA 1 kg? Do I need to manually set the fan speed in ‘Control’? Also, on the filament cartridge Bed Temp is listed: ‘No heat/60-80 °C’. Does this mean heating the bed ...
0
votes
0answers
27 views

Can I change the print speed 150 % for a specific layer range?

Can I change the print speed (150 %) for a specific layer range in PrusaSlicer; range is pointed out below:
0
votes
1answer
498 views

Increase volumetric flow rate using a longer nozzle

I'm looking to increase the printing speed, through increasing the volumetric flow rate, which is currently at 5 mm³/s. Larger amounts cause the feeding mechanism to skip steps. I'm running at ...