Questions tagged [tmc2130]

Questions using this tag should involve the TMC2130 integrated motor driver manufactured by TRINAMIC

Filter by
Sorted by
Tagged with
1
vote
1answer
37 views

How to interpret Trinamic driver continuous debug reporting?

In Marlin one can enable continuous debug reporting of Trinamic drivers with the command M122 S1 This sends lines similar to the following over the serial ...
0
votes
0answers
329 views

How to calculate the Vref and X_CURRENT for a TMC2130 stepper driver, knowing the rated current of the stepper motor?

I have written a question about this but I found new information in this video and I want to go more to the point. My motor "rated current" is 1.4V. I assume that this is the maximum current The guy ...
1
vote
1answer
142 views

Will the TMC2130 V3.0 stepper driver work with the Ramps 1.6 Plus board?

I want to buy the board Ramps 1.6 Plus. The description in the link says that is compatible with the driver TMC2130, but I found that there are two versions soldered in SPI mode. BIGTREETECH TMC2130 ...
1
vote
2answers
165 views

Is 12V and 15A enough to make work a Ramps 1.6 Plus and two stepper motors?

I want to make an order with this configuration Arduino MEGA 2650 R3 Ramps 1.6 Plus 2 TMC2130 2 Stepper motors 17hs3401 1 Fan But I am not sure what voltage and current would be enough to make it ...
0
votes
1answer
49 views

TMC2130 External VM RAMPS1.4

I'm attempting to replace my DRV8825's with TMC2130's on a Prusa i3 rework clone, 12v RAMPS1.4. motor currents have been accounted for. Since they don't work as well with 12V than with higher voltages,...
5
votes
1answer
1k views

Short to ground error using TMC2130 stepper drivers

I have recently got an MKS GEN L V1.0 board and 5 TMC2130s. (X, Y, two Z, E). I have wired it all up and uploaded Marlin 1.1.9 and after some quick troubleshooting I got the motors moving. Next day I ...