Questions tagged [tmc2130]

Questions using this tag should involve the TMC2130 integrated motor driver manufactured by TRINAMIC

Filter by
Sorted by
Tagged with
0
votes
1answer
69 views

TMC2130 External VM RAMPS1.4

I'm attempting to replace my DRV8825's with TMC2130's on a Prusa i3 rework clone, 12 V RAMPS1.4, motor currents have been accounted for. Since they don't work as well with 12 V than with higher ...
3
votes
0answers
65 views

Retraction fine but recovery occasionally just doesn't happen

I'm having issues with retraction. My printer prints very well normally, but has an intermittent problem with retraction: the retraction itself always happens, but sometimes the subsequent recovery ...
3
votes
1answer
80 views

Can I mix TMC drivers with A4988 on the same RAMPS board?

The closest thing I can find is this wiki page that state DRV8825 and A4988 can be mixed. However, the TMCs seem different, requiring more connections and offer more features, so I wonder if they can ...
1
vote
1answer
160 views

How to interpret Trinamic driver continuous debug reporting?

In Marlin one can enable continuous debug reporting of Trinamic drivers with the command M122 S1 This sends lines similar to the following over the serial ...
1
vote
2answers
443 views

Is 12V and 15A enough to make work a Ramps 1.6 Plus and two stepper motors?

I want to make an order with this configuration Arduino MEGA 2650 R3 Ramps 1.6 Plus 2 TMC2130 2 Stepper motors 17hs3401 1 Fan But I am not sure what voltage and current would be enough to make it ...
0
votes
0answers
1k views

How to calculate the Vref and X_CURRENT for a TMC2130 stepper driver, knowing the rated current of the stepper motor?

I have written a question about this but I found new information in this video and I want to go more to the point. My motor "rated current" is 1.4V. I assume that this is the maximum current The guy ...
1
vote
1answer
362 views

Will the TMC2130 V3.0 stepper driver work with the Ramps 1.6 Plus board?

I want to buy the board Ramps 1.6 Plus. The description in the link says that is compatible with the driver TMC2130, but I found that there are two versions soldered in SPI mode. BIGTREETECH TMC2130 ...
5
votes
1answer
1k views

Short to ground error using TMC2130 stepper drivers

I have recently got an MKS GEN L V1.0 board and 5 TMC2130s. (X, Y, two Z, E). I have wired it all up and uploaded Marlin 1.1.9 and after some quick troubleshooting I got the motors moving. Next day I ...