Questions tagged [tmc2208]
The tmc2208 tag has no usage guidance.
8 questions
2
votes
1
answer
3k
views
How to configure the TMC2208 Driver Voltage for a Creality Sprite Extruder in Klipper on Ender 3 Pro?
I'm trying to set up a Creality Sprite Extruder on my Ender 3 Pro without using the kit (installing the extruder alone).
I can see on the Sprite Extruder Pro Kit product page that the extruder ...
- 61
2
votes
1
answer
713
views
Will my 3D printer significantly get quieter after upgrading from Creality board 2.5.2 to BTT SKR Turbo 1.4
I have a Creality CR10 v3, which includes a board v2.5.2 with built-in TMC2208 stepper motor drivers.
I have read that it is still 8-bit (I thought that advertising a "silent board" meant it ...
- 205
1
vote
0
answers
216
views
TMC2208 v1.2 stepper motor drivers not detected on SKR 1.4 turbo with RepRap firmware
I've upgraded my board to SKR1.4 Turbo with RepRap firmware. Everything works, but motors move double the request. M112 reports them as 'no-driver-detected'.
...
3
votes
2
answers
846
views
Z axis no longer working on a working printer
I was printing an object and it started to drag so I stopped it.
Went to move the Z-axis up so I could clear the bed and Z-axis would not budge.
I switched the printer off and manually turned the ...
- 173
3
votes
1
answer
52
views
What is the maximum length of the TMC drivers signal wires?
I would like to place the TMC drivers (the stepsticks modules, in fact) on the side of my controller board for easier cooling.
What is the maximum length of the data wires? Specifically, Step and UART,...
- 4,600
1
vote
0
answers
321
views
TMC2208,BMG and 0.9 degree stepper motor, is this a bad combination?
My printer randomly freezes partway into the print whenever I use the combination of Marlin 2.0, TMC2208 stealthchop, a 3:1 geared extruder and an E3D 0.9° stepper in a Bowden configuration on the E ...
- 11
1
vote
0
answers
427
views
Why does my TMC2208 only rotate my stepper motor in one direction?
I have two TMC2208 stepper drivers, both with the exact same problem. They both only allow the motor to rotate in one direction. They are currently used inside a CoreXY style 3D printer. In my case, ...
- 411
2
votes
1
answer
2k
views
Is the Vref trimmer relevant on TMC2208 in UART mode?
I'm going to use TMC2208 stepstick in a printer and the firmware can control via UART the current during printing and during holding (static, no movement): the firmware has an explicit setting for ...
- 4,600