Questions tagged [tmc2209]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
1
vote
1answer
64 views

Is SD2209 the same as TMC2209 stepper drivers?

While shopping for TMC2209 stepper drivers I found advertisements "SD2209". Is this the same thing?
1
vote
1answer
84 views

Can I use different sized steppers for different axes?

So basically, I have 3 different types of steppers. A NEMA 23 stepper for the Z-axis, a good quality NEMA 17 for Y-axis and another lower quality NEMA 17 for X-axis. This setup should work right?. I'...
1
vote
0answers
50 views

TMC2208 v1.2 stepper motor drivers not detected on SKR 1.4 turbo with RepRap firmware

I've upgraded my board to SKR1.4 Turbo with RepRap firmware. Everything works, but motors move double the request. M112 reports them as 'no-driver-detected'. ...
0
votes
1answer
695 views

"Unable to read TMC UART 'extruder' register IFCNT" - Klipper and Robin Nano

I'm trying to use software UART for TMC2209 steppers on a BigTreeTech v1.2 and apply that to my Robin Nano v.1.1 using Klipper firmware. I declared a different pin for every driver and I edit my ...
0
votes
1answer
366 views

Error "TMC2208 or TMC2209 on Z2 requires Z2_HARDWARE_SERIAL or Z2_SERIAL_(RX|TX)_PIN

I am getting this error when I try to enable the Z2 driver for MKS Gen L V2.1 Could anyone help? Error "TMC2208 or TMC2209 on Z2 requires Z2_HARDWARE_SERIAL or Z2_SERIAL_(RX|TX)_PIN.
0
votes
0answers
75 views

How to install TMC2209 on MKS GEN L V2.1

how do I install TMC 2209 drivers into MKS GEN L V2.1 board. I do not need the home sensorless I just want to keep my dual z-axis motors cool and in sync. Thanks.