Questions tagged [tronxy-x1]

Questions using this tag should involve the Tronxy X1 3D printer manufactured by Shenzhen Tronxy Technology Co., Ltd.

Filter by
Sorted by
Tagged with
0
votes
0answers
20 views

Prints are Squished

My printer prints stuff okay but its all squished and much shorter than the model, My z Axis Esteps is fine I checked for loose wires and overheating but I can't figure it out. My Temp is 195, .15 ...
3
votes
1answer
195 views

Artefacts when printing parallel to X axis

If you can help me with troubleshooting the artefact shown in the attached photo that would be great. It only happens when I print the Benchy parallel to the X axis and when I print parallel to Y axis ...
5
votes
4answers
880 views

Can 3D printers, such as a TronXY X1, handle 24/7 projects?

I have an incoming project and the only 3D printer available to me is the TronXY X1. So the question is: Can it handle at least four days of continuous load or should I search for an alternate ...
4
votes
2answers
541 views

Ramps 1.4 with a power brick

I'm currently designing a RepRap 3D printer that will not have a heated bed. I have heard that it is possible to use a power brick with commercial printers lacking heatbeds. Is this possible with a ...