Questions tagged [ultimaker-2]

Questions about the second iteration of the Ultimaker printer and its variant versions, the Ultimaker 2+, Ultimaker 2 Extended and Ultimaker 2 Go.

Filter by
Sorted by
Tagged with
3
votes
2answers
98 views

Technique for removing support from Ultimaker 2+?

I have made some prints with the Ultimaker 2+ and Ultimaker 2 Extended+. The prints are in PLA. For slicing, I use Cura and I check the support checkbox (haven't gone to advanced settings to adjust ...
2
votes
3answers
645 views

PLA filament not feeding correctly with Ultimaker 2+

I've got the following PLA filament that is not feeding correctly into our Ultimaker 2+ It starts to feed and then all of the sudden, the wire 'eats' (read breaks, but not entirely) the plastic ...
3
votes
1answer
322 views

Flow Settings in Cura 2.4 for Ultimaker 2+ not available (suspected overextrusion filling small holes)

Cura 2.4 reports that the (printer-dependant) G-Code mode prevents the "Flow" (extrusion rate adjustment percentage) setting from being available. Why? I am using an Ultimaker 2+. Is a firmware update ...
6
votes
1answer
421 views

Recommended settings for ColorFabb Copperfill Filaments on a 0.25 mm Nozzle?

I switched out my 0.4 mm Ultimaker 2+ Nozzle the other day for the 0.25 mm and started using a ColorFabb Copperfill 2.85 mm filament. I am having some issues with it clogging and sticking to the bed ...
6
votes
4answers
317 views

Ultimaker 2 ticking sound coming from feeder

Recently, the ticking sounds started to come from feeder of my UM2. Inspecting it I have noticed that once in a while stepper motor jumps back for few steps. I have an idea of what can be the reason, ...