Questions tagged [underextrusion]

The tag has no usage guidance.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
2answers
97 views

Randomly underextruding/overextruding small part on CR-10

I am printing fairly cheap, but highly rated, PLA and not sure whether this is underextrusion or overextrusion; but it just looks bumpy and not clean. My settings: 195 °C at 60 mm/s bed temp 50 °C 0....
2
votes
0answers
64 views

Is there a possibility to add variable extrusion width to models with different wall features? (Simplify3d)

I've got a problem with the new "thin features" -solution in S3D. The model I want to print has some tapered thin walls, but also some thicker parts. I want to use this option for filling ...
2
votes
0answers
142 views

Walls are sometimes porous

I have a Tronxy P802E, which works pretty well for me. I currently use Ultimaker Cura 4.1.0. However, I occasionally get a weird problem where the walls in certain parts of certain prints will be ...
1
vote
1answer
111 views

Air printing/jamming midway through raft creation

For a school project, my teacher gave me a brand new Longer 3D printer to create parts with. After one good job, the printer cannot get past the raft creation without air printing. The thickness of ...
1
vote
1answer
34 views

CTC i3 Y-axis thin / no filament deposition

I have this CTC i3 printer; when I print square test prints, as it moves along the Y-axis back to zero (front). It extrudes lines but very thin or none at all. But opposite direction along the Y axis ...
1
vote
2answers
346 views

Printer extrudes too little filament at beginning and end of extrusion

I've bought a new type of filament (GreenTEC Pro Natural) for my Anycubic Mega i3 to print some food-safe cookie cutters. Now I have changed the print settings to an extruder temperature of 210 &...
0
votes
0answers
101 views

Flashforge Adventurer 3 PETG under extrusion after Rapid Move

I have recently started 3D printing and have had fine success with both PLA and ABS. Now I am trying to make some parts for which I believe PETG to be the correct material. However, I have run into ...
0
votes
0answers
197 views

Under-extrusion near the seam

I have an FLSUN QQ-S Pro and I'm trying to print a part consisting only of thin walls with PLA. I'm using Cura 4.8.0, "FLSUS QQ-S" profile. Unfortunately, near the seam there are signs of ...
0
votes
0answers
395 views

Under extrusion on one side, but only while printing support material

Trying to print a bracket for pliers, however the support material on the left side always fails by under extruding. The model is left-right symetrical, so the support is the same for both sides. ...
0
votes
1answer
1k views

Creality CR-10 problems with extrusion while printing

I have an extrusion problem with my creality CR 10 3D printer while printing. I am using a standard 0.4 mm nozzle with a 1.75 mm diameter PLA and I use Cura as my slicer. This printer ...