Questions tagged [wire-type]

Use this tag for questions that are concerned with the choice of wire for transporting certain electrical currents (for powering electronics, motors or transport a certain stream of information) or even mechanical power.

3 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
0answers
64 views

How can I clean out internal channels in an SLS polypropylene print?

After SLS printing any internal spaces retain the un-fused but packed powder that was in the bed. I am hoping to add channels as wire raceways internal to the part. Any experiences with this - is it ...
0
votes
1answer
295 views

"Unable to read TMC UART 'extruder' register IFCNT" - Klipper and Robin Nano

I'm trying to use software UART for TMC2209 steppers on a BigTreeTech v1.2 and apply that to my Robin Nano v.1.1 using Klipper firmware. I declared a different pin for every driver and I edit my ...
0
votes
0answers
87 views

Which wire size to connect 24 V PSU to board?

I'm building a new 3D printer (P3 steel type, 24 V setup) and I've been struggling with the wire gauge to connect the PSU (24 V, 15 A) to the SKR 1.4. From my calculations, 1.5 mm2 should be fine, but ...