Questions tagged [z-probe]

Use this tag for question that relate to switches or probes to level the bed either manually or automatically

8 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
50 views

BLTouch homing correct, but nozzle hits bed during print

So I have this exact problem as in this thread: BLTouch calibrated, nozzle still dives into the bed But I don't see a clear solution to that question, or I don't understand. After correct calibration ...
2
votes
0answers
126 views

Z homing problem; starts printing in the air

I have a DIY 3D printer with Marlin firmware. I use an LJ12A3-4-Z/BY sensor for the Z probe. Recently I have had a ridiculous problem with Z homing. In doing Z homing, it senses the bed, goes up, and ...
2
votes
0answers
639 views

BLTouch will not deploy, stow, or deploy when homing or auto leveling

So I am just about at my wit's end with these stupid BLTouch sensors - with 3 separate posts on this forum regarding them, my own posts even showing in the 'Similar questions' box at the time of ...
2
votes
0answers
170 views

BLTouch not covering the whole bed area

My problem is that the BLtouch doesn't probe the whole bed, in which the probe starts from the left edge and stops at the middle of the bed. I'm using Marlin 2 software and this the code in the ...
2
votes
0answers
99 views

Should center point of G29 matrix always be zero?

Questions: Should repeated applications of G29 (auto-level) result in the same matrix as long as nothing is loose or has otherwise mechanically changed? Should ...
1
vote
0answers
147 views

Tronxy X5SA not working properly after Marlin firmware installation

Yesterday I just installed Marlin firmware, 2.0.x bugfix version on my Tronxy X5SA (v6). I did it in the way explained on GitHub, with Visual Studio Code, Platform IO, Marlin auto build. I applied the ...
1
vote
1answer
2k views

Bed probing feed rates

I was watching a friend's Prusa run the bed-probe routine and I realized how pathetically slow mine is and takes forever. I want to speed it up. What parameters in Marlin's ...
1
vote
0answers
1k views

Marlin Bed-Leveling Vs Skew Correction

I've added a G29 command in my starting script to do bed leveling process before every print. It works fine and compensates my bed during prints. But when I print larger models, they're all skewed in ...