I currently have a print job that is about 50% done, been running for 2 hours with 2 hours remaining.  One side is curling/warping pretty bad, and I'm afraid there's no possible way this is going to finish without serious problems if I don't intervene.

So what I'm doing is either brilliant or idiotic, I'm not sure which: I've paused the print job, stuck some elmers glue below the curling part (with toothpicks, careful not to budge anything else), added a couple degrees to the heatbed (for pliability hopefully), put a small book on top of it to smash it on the glue and let it rest for a little bit (I'll report back if this was a horrible idea or not).

**So my main quesiton:** Is there any other techniques that you folks can recommend for a scenario like this?  McGuyver'y techniques to repair your in-progress print jobs?  Has anyone tried this technique I'm attempting and if so how successful was it?

In case it matters, I have an ANET A8 and generally send my print jobs to Octoprint (Raspi) from Cura with a Octoprint plugin (Windows).  Printing with PLA filament.  I've done quite a few successful prints recently, but this is the first one that goes from corner-to-corner on the heatbed ([this specifically][1]).  Printing at 207c with 60c heatbed (bumped up to 64 while glue settles).  It's in a cooler room of the house, and doesn't have an enclosure so I'm afraid the cool temp is affecting it.


Thanks


  [1]: https://www.thingiverse.com/thing:2189694