I am using "Pretty PETG" along with PrusaSlicer's consecutive print mode.

What I am noticing is that upon finishing the first print, the printer hits `MINTEMP BED Fixed`. I'm not sure if it's immediate because I let the prints run overnight but I assume the bed cools down and then the error is hit.

I'm just starting to learn G-code and my initial thought was there's an errant bed temperature instruction but the only `M140 S0` instructions I see are in the `end_gcode` and near the bottom of the file. Maybe there a `goto` in G-code which may be running after `M140 S0` which then causes the `MINTEMP BED` issue? Perhaps there's something else going on?