Hot answers tagged

1

Replace the probe The probe that came with the original BLTouch definitely had issues. There seems to be some slight difference in the original probe and was replaced with a spare probe that comes with the Ender 5+. There was an immediate change in success rate of turning on the device and other measurements. This blog post goes into more details. I was ...


1

Try calibrating your Z offset Based on this answer it sounds like the flashing red means there isn't enough clearance between your bed and your probe for it to operate. You might try raising your Z axis up a bit to let the probe achieve the minimum clearance necessary for deploying the probe. My guess is that your Z-offset isn't quite right and it isn't ...


Only top voted, non community-wiki answers of a minimum length are eligible