Skip to main content
Share Your Experience: Take the 2024 Developer Survey
1 vote
Accepted

Encountering some weird layer gaps on the last few lines of a particular print

I re-printed the model using Curas overlay settings and some stretched cubes to apply different settings to some of the fan blades: And once printed, the blade seen here at the very bottom looks like ...
J H's user avatar
  • 77
1 vote

Filament settings determination

Density Filament has a thickness and length. with those, you can treat it as a long cylinder. The volume of a cylinder is $$V=l\times \pi \left( \frac d 2 \right)^2$$ Measure a length of the filament, ...
Trish's user avatar
  • 22.1k
1 vote
Accepted

Can a print test be performed to determine nozzle and filament quality?

Mostly a Relative measure Assuming you have a well-known, well-printing nozzle and filament combination, then you can print a benchmark print, change one factor and then test with altered settings. ...
Trish's user avatar
  • 22.1k
1 vote

What is a good filament for a frame for holding high amp copper busbar?

I would use ABS, but you shouldn't rely on the filament. This is a job for insulation to take care of. You don't expect the holder to do any more than hold the component in electrical applications.
Kilisi's user avatar
  • 1,375

Only top scored, non community-wiki answers of a minimum length are eligible