9
votes
Accepted
How to change the voltage on a FLSUN QQ
I don't know if this is the case with all FLSUN QQ printers, but mine was indeed set to 220v as the instructions/user manual indicated. First I needed to remove the bottom of the printer. Then there ...
- 1,279
3
votes
Accepted
How can I print to my FLSUN QQ over Wi-Fi?
Assuming you use Ultimaker Cura to slice, there is a MKS plugin that allows connecting to the MKS WiFi module that comes with the QQ. Just follow these steps:
Install the MKS WiFi Plugin
Open Cura
...
- 1,279
1
vote
How can I print to my FLSUN QQ over Wi-Fi?
As the auto-install from the Marketplace described in this answer wasn't working , I did have to manually install the MKS WiFi plugin on my Mac (M1 MBPro). To do this I just:
Downloaded the GitHub ...
- 11
1
vote
Accepted
FLSUN QQ doesn't print and stops at Z=15 mm
A distance of 15 mm is about the height of the probe or Z-offset. That can be a clue.
Compare the G-code from the testprint with the G-code you sliced. It can give you other clues.
- 26
Only top scored, non community-wiki answers of a minimum length are eligible