New answers tagged

0

This is a well-known problem with Cura. The filament diameter is set to 2.85 mm by default (probably because Ultimaker printers use 2.85 mm filament). This will cause extreme under-extrusion if your printer uses 1.75 mm filament. Simply change the filament diameter to 1.75 mm in Cura's printer definition, and everything should be fine. Older versions of Cura ...


1

Reading all 49 pages of the manual was fruitless. I'm astonished that there is no reference to the filament diameter used in this printer. From 3dJake's web site comes a confirmation that the printer uses 1.75 mm filament. It's not a matter of changing a nozzle to use 2.85 mm filament, as the entire filament path is based, in this printer, on the 1.75 mm ...


Top 50 recent answers are included