3
votes
Height of printed part is incorrect
You should check that the steps per mm for your Z-axis are set correctly. This depends on the pitch of the leadscrews/threaded rods driving the axis and parameters of your steppers (microstepping and ...
2
votes
Height of printed part is incorrect
Thanks to your advices I pointed my effort on the root of the possible cause on the Z axis.
I swapped the Polou driver between x and z and clearly noted that now the problem is on x. I had to conclude ...
2
votes
Height of printed part is incorrect
You could check that the stepper driver IC for the z direction is not getting too hot while printing. If this is the case it may be that the current adjustment of the stepper driver is set incorrect ...
Only top scored, non community-wiki answers of a minimum length are eligible