4 votes

What can I do to remove the rounded corners using Junction Deviation?

Contrary to what's implied by its name, junction deviation does not produce rounded corners. It merely allows violations of the acceleration profile at corners that would be allowed if the corner were ...
3 votes
Accepted

Why would all of the Ender 5 Pro's axis motors (X, Y and Z) stop being able to move (all at once)?

The Creality V1.1.5 board was fried. I replaced it with a BIGTREETECH SKR MINI E3 V2.0 32BIT CONTROLLER. After struggling to find a corresponding firmware for the Ender 5 pro, the axis motors worked ...
1 vote

Why would all of the Ender 5 Pro's axis motors (X, Y and Z) stop being able to move (all at once)?

Usually, steppers not working can be found when the lines are broken. Often this is an unplugged Stepper, but OP checked that. That 3 steppers at once failed could indicate a bad firmware update, ...
  • 19.8k
1 vote

What can I do to remove the rounded corners using Junction Deviation?

When a junction deviation is set too low it will mess up every other thing you have been trying to do to perfect your extrusion. It messes up retraction, linear advance, s-curve, the entire print. I ...
1 vote

While heating, BLTouch mesh data gets worse and worse the more times you probe

It looks like the changes are always going in the same direction for a given probe point (each point increases steadily or decreases steadily, there is no oscillation). This means that the bed is not ...
  • 3,876
1 vote
Accepted

Different Probe Z offset for G28 and G29

I'm answering my own question here. The Issue was that I set Z_MIN_POS to -2.0 I guess these 2 mm were subtracted from G28...
1 vote
Accepted

BigTreeTech mini e3 V1.2 endstop installation

You do not need to connect the red (+) wire of the endstops. The controller board uses a technique to ensure the signal is 3.3 V or ground, see the top left schematics of this link (will insert ...
  • 31.4k
1 vote
Accepted

Thermal runaway triggers when raising temperature amid cooldown

Yes there are ways to tune false positives. For Marlin firmware you can find these option in the Configuration_adv.h file. From the file itself you can read what you need to do: ...
  • 31.4k

Only top scored, non community-wiki answers of a minimum length are eligible