New answers tagged

2

After watching the video, I see three unwanted behaviors, all consistent with a hypothesis that the printer is reading corrupted data from the gcode file: Moves to low but nonzero X or Y coordinate then immediately back are not homing, but misreading of the X or Y value for a G1 move command - perhaps flipping a bit so that a leading 1 looks like a 0, or ...


4

In my opinion, PrusaSlicer aims for the most robust printing process at the cost of a higher demand for material in the standard configuration. I totally agree with @0scar that the small pillars have a high tendency of falling over with increasing height of the print. To handle the waste of material you could use the feature "Paint-On Supports" (...


Top 50 recent answers are included