5
votes
Accepted
Can I mix TMC drivers with A4988 on the same RAMPS board?
Yes you can mix different drivers, including the TMC drivers (e.g. using for X and Y only).
How you do that is described in this instructable.
Please do note that, from observations, the 8-bit based ...
4
votes
Accepted
Short to ground error using TMC2130 stepper drivers
I have fixed it. I tried uploading the bugfix version of Marlin and no luck. Then I noticed a loose jumper wire that connected the driver to the board and when re-installing it I noticed it didn't ...
2
votes
Accepted
Is 12V and 15A enough to make work a Ramps 1.6 Plus and two stepper motors?
The easiest way to know how powerful the PSU should be is to download from https://github.com/rcarlyle/StepperSim the Excel workbook which simulates the power absorbed by the stepper motor. Input the ...
2
votes
How to interpret Trinamic driver continuous debug reporting?
In the Marlin source code I found the function responsible for the report logs: report_polled_driver_data in ...
1
vote
Accepted
Will the TMC2130 V3.0 stepper driver work with the Ramps 1.6 Plus board?
Well I found that I can use a DuPont cable to connect the diag1 pin to the right endstop
There is also a beta functionality in the Marlin firmware I haven't tried: Just uncommenting ...
Only top scored, non community-wiki answers of a minimum length are eligible
Related Tags
tmc2130 × 8stepper-driver × 5
marlin × 4
stepper × 2
ramps-1.6 × 2
creality-ender-3 × 1
ramps-1.4 × 1
arduino-mega-2650 × 1
bigtreetech × 1
retraction × 1
power-supply × 1
ramps × 1
mks × 1
skr-v1.3 × 1