New answers tagged

0

When I make it move 1 mm with the encoder it moves more like 15 mm. 15 is suspiciously close to 16. Perhaps the motor driver is operating in full step mode rather than microstepping. This could be due to a manufacturing defect in the electronics. To diagnose this you would need a multimeter to measure the voltage on the microstepping select pins of the ...


0

To answer your question explicitly, Am I supposed to manually fix this with steps per mm setting No, you should only do that if the incorrect value has been set, the reported value of 80 corresponds to the values found in all configuration.h files for the boards used by the Ender 3. This value implies the use of stepper drivers with a 1/16 micro-stepping ...


Top 50 recent answers are included