mer2329
  • Member for 3 years, 10 months
  • Last seen more than 3 years ago
Why is a heated bed important?
4 votes

There is no simple answer. I will only cover the three main filaments: PLA, ABS, and PETG. ABS: ABS likes to warp, and dislikes breezes and temperature changes. so a heat bed is required, as is ...

View answer
Threads for nozzle (Anet A6 extruder)
3 votes

look for MK8 or V6 nozzles that are for 1.75mm filament. but to answer your question the exact threading is M6 x 1mm thread pitch both MK8 and e3d v6 nozzles use m6 x 1mm pitch Source: manual ...

View answer
Prusa i3 PLA fails to stick to first layer on curves
1 votes

possible solutions 1) try and increase the extruder temp by 5 degrees for the first layer and see if that helps 2) disable coolign for the first few layers. 3) try adding some PVA glue (washable ...

View answer
Filament clogging just above feeding tube - Duplicator 6
0 votes

that looks like heat creep. heat creep is the result of in too much heat in the hot end creeping its way into the cold end. and results in a gradual clogs mid print. to combat heat creep you need to ...

View answer
Anet A8 Hot End Spares Quey
0 votes

that item is for a bowden setup. (the a8 does not come with a bowden setup, but can be modded to have one.) when installing the bowden setup on a a8, the first thing you will need to do is move the ...

View answer