Dave Corbett
  • Member for 3 years, 6 months
  • Last seen more than 3 years ago
  • Des Moines, Iowa, USA
How to avoid stringing?
4 votes

I've been able to reduce stringing by reducing the nozzle temp in 2°C increments until it goes away. You'll also want to increase your retraction settings a bit. The problem is caused by the plastic ...

View answer
What voltage does the Creality Ender-3 run at?
2 votes

The Ender 3 and the CR-10 printers use the same board which runs on both 12V and 24V. I have one of each and have to be careful swapping parts between the two.

View answer
Finding a reputable seller for CR-10S
2 votes

I’ve bought two printers (CR-10S and Ender 2)from Tiny Machines in Houston Texas. They unbox them from China and assemble them and make a test print. You get a checklist of the tests performed. ...

View answer
How to achieve dimensional accuracy of printed parts
2 votes

I print several pats that use 2.5mm "Pogo pins" which are spring-loaded electric contacts. I've found that many variables will influence the size of the holes I have in my design. Flow, temperature ...

View answer
Thick wall or solid part of an otherwise medium-fill part
1 votes

I believe the solution is to use more walls in Cura. Here is a 50mm cylinder with a 20mm hole. I specified 10 walls in Cura. This should give extra plastic for the screw to bit into, but not take ...

View answer