Skip to main content
Joel Coehoorn's user avatar
Joel Coehoorn's user avatar
Joel Coehoorn's user avatar
Joel Coehoorn
  • Member for 5 years, 10 months
  • Last seen more than a week ago
31 votes
9 answers
70k views

What kinds of gaps/tolerances should I use when designing pieces that fit together?

10 votes
2 answers
27k views

How do I know when filament is getting old, and what things can I do to correct for it?

8 votes
3 answers
3k views

How to determine shell thickness for parts?

8 votes
4 answers
442 views

Does Cura have an algorithm for any infill percentage or does it just have specific patterns?

8 votes
1 answer
1k views

What's so special about cleaning filament?

6 votes
1 answer
305 views

Editing a G-code file for different material

6 votes
2 answers
24k views

Move print bed to front at the end of a print rather than the back

5 votes
2 answers
2k views

Show the time index in Cura Layer View playback

5 votes
1 answer
4k views

Can I use a 0 mm top layer thickness in Ultimaker Cura to create an open box?

4 votes
1 answer
1k views

3 vs 4 bearings for y axis travel

4 votes
2 answers
2k views

Slow down first layer above infill in Ultimaker Cura

3 votes
1 answer
2k views

What hairspray brands are known to contain PVA / PolyVinylpyrrolidone

3 votes
1 answer
545 views

Is a BLTouch probe used during a print after the first layer?

3 votes
4 answers
6k views

How thick is 0.1 mm?

3 votes
1 answer
852 views

Ultimaker Cura 3.6 choosing to fill in narrow walls with diagonal striping

3 votes
4 answers
1k views

How specific can I get setting layer heights?

3 votes
1 answer
523 views

Alternating number of lines for the shell between layers

3 votes
4 answers
16k views

Good lubricants for moving parts?

2 votes
1 answer
332 views

Replacement Nozzle options

2 votes
2 answers
3k views

What do I need to do to recalibrate my printer after updating the firmware?

1 vote
1 answer
73 views

Uneven motion in X and Y directions after attempting to adjust Z motion in ADVI3++

1 vote
2 answers
755 views

Pause, rehome X/Y, resume

1 vote
1 answer
121 views

Slow down a specific set of extruder moves

1 vote
1 answer
207 views

Can Cura alert me (give a warning) if it estimates times for layers are too long?

0 votes
2 answers
2k views

Brim around just one section

0 votes
0 answers
637 views

Tuning time estimates in Cura

0 votes
0 answers
40 views

Will the inside of a vehicle be too hot for PLA? [duplicate]