Marcus Adams
  • Member for 3 years, 2 months
  • Last seen more than 1 year ago
Stuttering extrusion after layer change
3 votes

You retraction settings may be too high. Direct drive extruders require less retraction than Bowden style extruders. Typical retraction settings for direct drive are 1.5mm at 50mm/s and for Bowden, ...

View answer
How small may I design objects for the Prusa i3 MK3?
1 votes

This is dependent on the slicer and the nozzle diameter. Typically, you cannot print a wall smaller than twice the nozzle diameter because walls need an inner and outer line. Therefore, your slicer ...

View answer
Layer shifting on product printing after raft support structure
0 votes

I'm guessing that the bed in the offending corner is farther away and your raft is curling and lifting off the bed in that corner, and your nozzle it hitting it. Try releveling your bed, paying ...

View answer
Speed issue with Slic3r and Marlin
0 votes

Make sure that on the Print Settings tab, under Advanced, you have set the Extrusion widths for your custom nozzle settings.

View answer