kane
  • Member for 3 years, 1 month
  • Last seen more than a month ago
Why won't my filament feed through the extruder anymore?
Accepted answer
6 votes

I figured out the issue. I think I was shoving it in the wrong hole. I took apart my extruder component. There's a good video on it here. But basically, you just have to loosen the two bottom screws ...

View answer
What causes this "stringing" and can my print recover from this?
2 votes

Both @Oscar and @Trish have identified the problem in their answers. Upon further investigation, I believe I found the root of the problem. The Monoprice Select V2 has what I think is an inherent ...

View answer