kolosy
  • Member for 3 years
  • Last seen more than a month ago
When installing a glass bed, what do you change?
Accepted answer
3 votes

The most common way to install a glass bed (assuming it's literally a piece of borosilicate glass) is with binder clips. Glass is an insulator, so you may need to adjust your bed temps by a few ...

View answer
Monoprice Maker Select v2 stops extruding after about 200-300 mm
Accepted answer
3 votes

Looking at the tread pattern on the filament, I think it's getting stuck. Note that the teeth marks get closer together as you go up the fillament, and the last one is a big divot, that looks like the ...

View answer
Is there any better way to make this transparent dome?
3 votes

The filament seems to lose its translucency past a certain thickness That's exactly the point. Think of translucency as a percentage of light being allowed through, per amount of material. 2x the ...

View answer
Sunken and rough bottom layer
2 votes

I know you said you don't want to change the Z height, but it does look like you're printing a bit too far from the plate. I would recommend adjusting your Z-offset if you can, or adjusting the limit ...

View answer