As of May 31, 2023, we have updated our Code of Conduct.
Perry Webb's user avatar
Perry Webb's user avatar
Perry Webb's user avatar
Perry Webb
  • Member for 4 years, 1 month
  • Last seen this week
5 votes
1 answer
3k views

What are ways to avoid heat creep?

4 votes
0 answers
122 views

What foundation designs are adequate for a 3D-printed one-floor building larger than 200 square meters?

4 votes
3 answers
623 views

Material for printing orthotics

4 votes
2 answers
3k views

What is the reinforcement for 3D printing concrete cement?

4 votes
1 answer
289 views

Is there a slicer that can set the print speed for each layer as a function of the layer area?

3 votes
4 answers
12k views

What is the best technique to improve removing PETG from the print bed?

3 votes
4 answers
4k views

How do I get circles on small interior holes to adhere to the bed?

3 votes
2 answers
5k views

Wavy lines on 1st layer only

2 votes
1 answer
146 views

Printing dental temporary crowns

2 votes
2 answers
113 views

Has anyone applied four 200 x 200 mm PEI sheets to a 400 x 400 mm bed?

2 votes
2 answers
112 views

Friction between nozzle material and abrasive filaments

2 votes
1 answer
2k views

What is the best build surface for PETG?

1 vote
1 answer
237 views

Will glue sticks form a barrier on a build surface to prevent PETG from damaging the surface?

1 vote
2 answers
191 views

Way to add identity to an all metal hot end

1 vote
1 answer
144 views

Is there anyone now permanently living in 3D-printed houses or buildings?

1 vote
1 answer
91 views

Wrench drops temperature of heater block when tightening nozzle

1 vote
0 answers
139 views

Does PLA become brittle with age? [duplicate]

1 vote
2 answers
275 views

Do you have trouble with 3D printer on UPS during short power outages?

1 vote
1 answer
301 views

Proper hotend heater for Reprap x400 Pro V3

0 votes
1 answer
62 views

What is the best way in SketchUp to align the bottoms of all objects to the x-y origin plane?

0 votes
1 answer
37 views

Some procedures to improve 1st layer

0 votes
1 answer
42 views

Eliminating unwanted internal surfaces

0 votes
2 answers
523 views

What happens if you use high temperature PTFE tape with the heater block?

0 votes
1 answer
180 views

What technics are you using to seal between the throat tube and nozzle?

0 votes
1 answer
116 views

Is it practical to build a separate hotend temperature controller to assemble hotends without taking up printer time?

0 votes
3 answers
471 views

What can cause a 3D printer to catch on fire?

0 votes
2 answers
140 views

What is cause of blob when layer area reduces by 50%?