Last call to make your voice heard! Our 2022 Developer Survey closes in less than a week. Take survey.
user avatar
user avatar
user avatar
FarO
  • Member for 5 years, 11 months
  • Last seen this week
9 votes
2 answers
561 views

How to optimally make a 3D model of an object using photos?

7 votes
3 answers
544 views

Can I have a glass bed with only the center heated?

7 votes
1 answer
838 views

How to theoretically calculate the maximum acceleration?

5 votes
1 answer
3k views

Which material "creeps" (plastic deformation) the least (or nothing at all) under pressure after being printed?

5 votes
2 answers
2k views

Why does PETG require slower speed?

5 votes
1 answer
456 views

Which filament to use for an application involving water circulation?

4 votes
2 answers
551 views

How to add tolerances/gaps in 123d Design?

4 votes
2 answers
918 views

What are my options if I want to install a bed levelling sensor capable of operating at 100 °C?

4 votes
2 answers
185 views

How can I upgrade the drivers in the Printrboard rev. D?

3 votes
4 answers
370 views

What are the options for an insulated but still transparent door for a 3D printer enclosure?

3 votes
1 answer
266 views

Are there multi-filament hardened nozzles or equivalent systems?

3 votes
2 answers
728 views

Is a slower outer perimeter speed still meaningful?

3 votes
1 answer
50 views

How to interpret various thermal-related filament properties?

3 votes
1 answer
615 views

How to use a BLTouch or equivalent touch probe to 3D scan objects with a 3D printer?

3 votes
1 answer
497 views

What are the downsides of high stepper current OR power?

2 votes
1 answer
254 views

Why and how am I supposed to change the extrusion multiplier? [duplicate]

2 votes
1 answer
183 views

How to extract 3D information from a 3D model for calibration?

2 votes
2 answers
723 views

Can UV cure inside opaque or more massive printed object?

2 votes
2 answers
208 views

How to slice a model to ensure at least a certain amount of filament per layer?

2 votes
1 answer
179 views

How to find correct part cooling fans?

2 votes
1 answer
1k views

Is the Vref trimmer relevant on TMC2208 in UART mode?

2 votes
1 answer
30 views

What is the maximum length of the TMC drivers signal wires?

2 votes
3 answers
303 views

Is it normal for belt tension to differ between sides of a CoreXY printer?

1 vote
2 answers
85 views

How to test all pins of a STM32 board?

1 vote
1 answer
2k views

What are the changes between BLtouch 3.0 and 3.1?

1 vote
1 answer
258 views

How to set multiple draft shields in Prusaslicer?

1 vote
0 answers
33 views

What specifics do models need to have to estimate the maximum acceleration my printer can withstand?

1 vote
2 answers
2k views

Are all glue sticks PVA-based? How to find out?

1 vote
2 answers
833 views

How can I add an offset to the first layer to increase clearance?

1 vote
0 answers
365 views

How to solve this extrusion problem?