user avatar
user avatar
user avatar
Mick
  • Member for 5 years, 11 months
  • Last seen this week
  • United Kingdom
12 votes
Accepted

What is G92 used for in G-code

11 votes
Accepted

Is there a way to save a multi part print if one fails?

7 votes
Accepted

Under extrusion with Cura 3.1

7 votes
Accepted

Adhesion problems with masking tape

7 votes
Accepted

Is PETG filament food safe?

7 votes
Accepted

Installing bowden tube into E3D V6

6 votes

Why is a heated bed important?

6 votes
Accepted

Hot end jamming very quickly

6 votes
Accepted

Tronxy Marlin boards (two of them) reboot when asked to heat bed

6 votes
Accepted

Nozzle insulation gone, can the printer be damaged?

6 votes

Needle Hotend for nonplanar printing

5 votes
Accepted

What filaments allow air to pass but not water vapor?

5 votes

Wavy walls with Ultimaker Cura

5 votes

Initial Layer Line width in PrusaSlicer

4 votes

Cold end coupler stuck on Bowden tube

4 votes

Good Designing Software for cheap

4 votes

Why Cura flattens first layer of round objects?

4 votes

Why does my PLA filament keep snapping?

4 votes
Accepted

How does 3D printing over USB work?

4 votes

Ripple in layers

4 votes

Strange problem with quality, what might be the reason for these bubbles?

3 votes

Inconsistent inner/outer dimensions

3 votes

Anycubic Chiron does not print correctly

3 votes

What is the strongest filament type?

3 votes
Accepted

Is there any 3D-printing software that supports Raspberry Pi?

3 votes

Can I resolder a power connections with a partially burnt board

3 votes

What determines print start location on the build plate?

3 votes

Please suggest parameters for 0.5 mm diameter nozzle

3 votes
Accepted

A free simulation program

3 votes

Small part bed adhesion