Skip to main content
3D Printing

Return to Answer

fixed capitalization, punctuation, grammar, spelling, formatting
Source Link
edit approved Jun 22, 2021 at 21:56
agarza
edit approved Jun 22, 2021 at 21:56
agarza
  • 1.7k
  • 2
  • 16
  • 33

firstFirst, check that your belts are tight, on the x axisX-axis and the bed. ifIf not, tighten them.

secondSecond, grab the hot end and wiggle the gantry, and make sure it is not loose, if. If there is any play at all, tighten the eccentric nuts.

ifIf this doesntdoesn't fix your problems, check out this playlist iI put together for the enderEnder 3 v2V2, it should answer everything.

Ultimate guideGuide to the enderEnder 3 v2V2 -Technivorous

first, check that your belts are tight, on the x axis and the bed. if not tighten them

second, grab the hot end and wiggle the gantry, and make sure it is not loose, if there is any play at all tighten the eccentric nuts.

if this doesnt fix your problems, check out this playlist i put together for the ender 3 v2, it should answer everything

Ultimate guide to the ender 3 v2 -Technivorous

First, check that your belts are tight, on the X-axis and the bed. If not, tighten them.

Second, grab the hot end and wiggle the gantry, and make sure it is not loose. If there is any play at all, tighten the eccentric nuts.

If this doesn't fix your problems, check out this playlist I put together for the Ender 3 V2, it should answer everything.

Ultimate Guide to the Ender 3 V2

Source Link
Technivorous
Technivorous
  • 176
  • 5

first, check that your belts are tight, on the x axis and the bed. if not tighten them

second, grab the hot end and wiggle the gantry, and make sure it is not loose, if there is any play at all tighten the eccentric nuts.

if this doesnt fix your problems, check out this playlist i put together for the ender 3 v2, it should answer everything

Ultimate guide to the ender 3 v2 -Technivorous