Yes. These settings work for Ultimaker as well. Set the printer to print PLA, and put brown tape on the bed under the print. Set the layer to 0.1mm, set the initial layer to 0.1mm.
Dont over heat the PP or when it cools it will shrink tons making it want to peel off. PLUS if you dont let the PP go below its Tg (80centigrade) by making the bed too hot it will stay molten and eventually stick to the nozzle making a truly pants print, and probably detach itself.
I have been making tiny detailed little components with PP this evening, just about to put 21 on to make and then off to bed!