Skip to main content
3D Printing

Return to Question

Improved formatting
Source Link
0scar ♦
0scar ♦
  • 37.1k
  • 12
  • 67
  • 155

So, I've gotten the gcodeG-code to work regarding the waiting 10 seconds as I wanted it to. However, does anyone know if there is any gcodeG-code that exists that will allow me to manually set the height of the heatbed? I'm trying to find out after each layer if I give it 10 seconds to fully 'cure' or 'cool' to see if the results will be better. But I need to move the bed down away from the extruder. Thanks in advance to any tips!

So, I've gotten the gcode to work regarding the waiting 10 seconds as I wanted it to. However, does anyone know if there is any gcode that exists that will allow me to manually set the height of the heatbed? I'm trying to find out after each layer if I give it 10 seconds to fully 'cure' or 'cool' to see if the results will be better. But I need to move the bed down away from the extruder. Thanks in advance to any tips!

So, I've gotten the G-code to work regarding the waiting 10 seconds as I wanted it to. However, does anyone know if there is any G-code that exists that will allow me to manually set the height of the heatbed? I'm trying to find out after each layer if I give it 10 seconds to fully 'cure' or 'cool' to see if the results will be better. But I need to move the bed down away from the extruder.

Source Link
Buda
Buda
  • 3
  • 1

Setting Heat Bed Height Manually Mid-Print?

So, I've gotten the gcode to work regarding the waiting 10 seconds as I wanted it to. However, does anyone know if there is any gcode that exists that will allow me to manually set the height of the heatbed? I'm trying to find out after each layer if I give it 10 seconds to fully 'cure' or 'cool' to see if the results will be better. But I need to move the bed down away from the extruder. Thanks in advance to any tips!