I acquired an Anycubic Chiron yesterday. I went through the leveling procedure and I think the level test print came out okay so I printed a 20 mm calibration cube and a benchy. Both of these came out with a sort of spongy consistency.

I have no idea what could be causing this so some advice would be appreciated.

I'm using Cura 4.0.0 and printing in PLA.

I acquired an Anycubic Chiron yesterday. I went through the leveling procedure and I think the level test print came out okay so I printed a 20 mm calibration cube and a benchy. Both of these came out with a sort of spongy consistency.

I have no idea what could be causing this so some advice would be appreciated.

I'm using Ultimaker Cura 4.0.0 and printing in PLA.

I acquired an Anycubic Chiron yesterday. I went through the leveling procedure and I think the level test print came out okay so I printed a 20mm calibration cube and a benchy. Both of these came out with a sort of spongy consistency.

I have no idea what could be causing this so some advice would be appreciated.

I'm using Cura 4.0.0 and printing in PLA.

I acquired an Anycubic Chiron yesterday. I went through the leveling procedure and I think the level test print came out okay so I printed a 20 mm calibration cube and a benchy. Both of these came out with a sort of spongy consistency.

I have no idea what could be causing this so some advice would be appreciated.

I'm using Cura 4.0.0 and printing in PLA.