All Questions
6 questions
1
vote
0
answers
108
views
Bioprinter does not extrude Anet A8 Marlin
I have a modified Anet A8 that is supposed to print hydrogels
(paper : Ultra-Low-Cost 3D Bioprinting, Kahl M et al. 2019).
For this to work, we do not need any temperature-related settings, however, I ...
- 19
4
votes
1
answer
4k
views
Massive over extrusion after changing firmware
I have an Anet A8 printer (no modifications) and first printed a calibration cube. It came out okayish, within expectations. Afterwards I flashed the firmware to Marlin 1.1.9 and since then have very ...
- 313
1
vote
1
answer
755
views
Stuck getting ANet A8 Printer to build layers [duplicate]
I have excitedly decided to get my feet wet in the 3D printing world, and being that budget is fairly small got myself an ANet A8 3D printer. I have it all assembled and am able to 'print' however I ...
- 113
7
votes
3
answers
1k
views
Anet A8 bad/inconsistent extrusion after changing nozzle
I just changed my nozzle on my Anet A8 after it was fully used up. When I started printing with my new 0.4 mm nozzle (same as before) my extrusion was VERY bad and inconsistent, even so bad I ...
- 71
2
votes
1
answer
2k
views
Cooling time query ABS
I printed Thingiverse "Benchy" at the default Anet settings for ABS, hot end and bed, as a first test. The result was fair but needs a bit of tweeking. The model was removed from the "hot bed" and set ...
- 367
6
votes
1
answer
883
views
Filament not extruding
I've recently bought an Anet A8, and haven't been getting good prints with it. I noticed there was filament leaking from the top of the hot end and pooling, eventually dripping over onto my prints. I ...
- 161