All Questions
6 questions
1
vote
1
answer
2k
views
G29 Bed Level not doing anything on Marlin 2.0
I've just updated my Anet A8 with the blue bed level sensor to Marlin 2.0 .
Both pressing the Level Bed button on the display or using G29 after ...
3
votes
1
answer
9k
views
Bed size and nozzle homing offset in Marlin 1.1.9 firmware
This is driving me up the wall, hope somebody can give me some advice...
I have an Anet A8 (metal frame, so 'AM8'). Bed is the original 220x220 mm. When the nozzle is at the X/Y end stops it ...
- 31
2
votes
1
answer
3k
views
Configuration of the Anet A6 full graphic LCD 12864 on an Anet A8
I finished fixing my Anet A8 about the 3DTouch sensor working with the LCD2004 stock display, I am installing the full graphic display LCD 12864 (for Anet A6) but when I compile Marlin 1.1.9 the ...
- 21
5
votes
1
answer
1k
views
Bed heating from Pronterface works, but not from LCD menu nor from SD print
Running my Ultrabase (glass plate) through a MOSFET on an stock A8 board with Marlin 1.1.8. When I do PID tune through Pronterface (by using the M303 E-1 C8 S70 ...
- 73
6
votes
1
answer
9k
views
Setting custom x/y bed bounds for Anet A8/marlin
I have an Anet A8 that I just flashed with the latest Marlin firmware (1.1.9). I'm sending prints to my printer with Ultimaker Cura via OctoPrint.
I have affixed a PEI surface to my bed that's about ...
- 163
4
votes
1
answer
1k
views
SkyNet3D firmware home settings
I recently installed SkyNet3D V1.1 on my Anet A8 printer. When I prepare the printer and select "auto home" it moves the head close to the upper right hand side of the bed. How do I change these ...
- 171