1
$\begingroup$

So I have printed multiple benchies with various slicer settings. I have also made sure my bed is leveled well.

But no matter what I do, I get these over extrusion whenever my nozzle is moving in diagonals (left-right). It's always this same angle where it goes wrong.

Has anyone else who has faced this and has figured out know what the issue can be? I'm new to 3D printing so the help would be very much appreciated.

Picture of sample extrusion problem

Improve this question
$\endgroup$
1
  • 1
    $\begingroup$ Please tell us what printer, what slicer, and what firmware you are using. Your slicer settings will help as well. $\endgroup$
    – Davo
    Commented Jun 10, 2021 at 15:47

1 Answer 1

Reset to default
2
$\begingroup$

The issue was that the X-axis belt was super loose, figured it after someone pointed it out on Reddit:

swordfish45

You have an extremely loose x belt. That's the root cause of all your problems I can see in these pics.

Improve this answer
$\endgroup$
0

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .