All Questions
2 questions
4
votes
2
answers
7k
views
Anet A8 Calibrated but print sizes are wrong
Anet A8 printer, Github Marlin, Repetier Host, Cura slicer
Just setting up printer and printed 20mm calibration cube from Thingiverse. X,Y,Z & E not too far off but not quite right (centre hole ...
3
votes
1
answer
491
views
Z axis stopped part way through print
I got an Anet A8 for Christmas.
I am trying to print a calibration tower and the z axis stops lifting at approximately 100mm.
I checked that the gantry is able to travel along the full length of the ...