0
$\begingroup$

I have MKS TinyBee board recently purchased. The temperature sensor reading gives either 'Err' or '0'.

I have tried all possible sensors in the Marlin table configuration, but still none of them worked. As well as 3 different sensors. Is the board faulty or I'm missing a setting?

Photo of temperature sensor display

Improve this question
$\endgroup$
4
  • $\begingroup$ Did you try plugging the thermistor into the other thermistor ports on the board to see if it will work then? $\endgroup$
    – Eric Gerwing
    Commented Jun 4, 2022 at 15:19
  • $\begingroup$ I tried both ports, still the same $\endgroup$
    – Kld Murshed
    Commented Jun 5, 2022 at 22:45
  • $\begingroup$ Did you find a way around this problem? $\endgroup$
    – Geo Gomez
    Commented Aug 7, 2022 at 8:59
  • $\begingroup$ How about something simple... have you check continuity on the wire between the logic board and the sensor? $\endgroup$
    – codingCat
    Commented Aug 8, 2022 at 1:24

1 Answer 1

Reset to default
2
$\begingroup$

I get this issue, more or less the same. In my case, it wont read temperature UNLESS both X and Y steppers are active. If any of those is open, it displays err/0.

Improve this answer
$\endgroup$
1
  • $\begingroup$ Welcome to 3D Printing! If you have a NEW question, please ask it by clicking the Ask Question button. If you have sufficient reputation, you may upvote the question. Alternatively, "star" it as a favorite and you will be notified of any new answers. $\endgroup$
    – agarza
    Commented Aug 7, 2022 at 12:48

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .