New answers tagged

1

The top image looks as if the (top) layer(s) are under-extruding, the walls don't appear to be suffering from the same problem. The following image from a recent print is typical for an FDM product. The deposited lines need to touch (actually, slightly overlapping, but the slicer will take care of that) each other: You will see texture (especially when ...


1

This is the answer which was taken from the OP's question. If the OP cares to post their own answer, then this wiki answer can be deleted I discovered that X-axis belt was very loose. Tightened it, and now reprinting. Will update here with results. I replaced the Bowden tube (old one was partially clogged) and upgraded to better PLA. Much better results now!...


Top 50 recent answers are included